GMB 125-6060 OE Replacement Water Pump
GMB 125-6060 OE Replacement Water Pump
- Make sure this fits by entering your model number.
- 100% factory tested for leakage and dimensional precision
- Bearing noise and durability tested
- Designed to match OE coolant flow rate and pressure
- Precision-ground shaft and hub accept OE fan clutches perfectly
- All required hardware included for easy installation
- Fit type: Vehicle Specific
Product description
GMB OE Replacement Water Pumps are precision-built and balanced that meet or exceed original equipment specifications. GMB is one of the world's largest designers and producers of automotive products for most European, Asian and domestic built vehicles. products are engineered and built utilizing the strictest design and manufacturing guidelines, with the finest quality assured through ISO 002 programs.
From the manufacturer
For more than 70 years, GMB has been a global bearing manufacturer. GMB bearings are at the core of every part made.
- Water Pumps
- Fan Clutches
- Wheel Bearings
- Universal Joints
- Fuel Pumps
- Timing Kits
GMB Water Pump
Quality Performance and Maximum Durability
GMB has decades of manufacturing and engineering experience within the Water Pump category, serving OE car makers including Hyundai, Kia, GM, and Chrysler. All Water Pumps are manufactured in GMB’s factories in Japan, Korea, Thailand, and China utilizing strict OEM specifications.
Genuine GMB bearings ensure product quality and safety.
Maximize the Life of Your GMB Water Pump
When replacing your GMB Water Pump also check the conditions of the:
- Thermostat.
- Radiator.
- Timing Belt and/or Fan Belt.
- Belt Tensioner and Idler Pulleys.
- Fan Clutch.
- Cooling Fan.
If any of these are damaged or need replacement, they can result in premature water pump failure and/or loss of cooling performance.
|
|
|
|
|---|---|---|
Prevent ContaminationRemember to flush your cooling system before installing the new water pump to remove any debris or rust from the cooling system. Use only the manufacturer specified coolant for your vehicle. Only use distilled water with coolant mixtures. |
Prevent Leakage at Installation SurfaceEnsure the mounting surface is cleaned of all debris prior to installation. For paper or metal gasket, apply a thin, even coat of sealer to both sides of the gasket. For O-Rings or rubber gaskets, apply a coating of grease around the gasket. Do not use any sealers for rubber gaskets. Follow manufacturer’s specifications for any bolt torques. |
Prevent Future FailuresTake special care when applying gasket sealant to avoid future failures. Any sealant that seeps into the coolant system can be caught in the mechanical seal and cause very quick failure of shaft seal. This can cause immediate leakage from the mounting surface. |